![]() Your photo frame is now ready to hang and display your precious memories and artwork. This will allow your print or photo to slightly expand and contract with changes in relative temperature of the room over time and help avoid severe cockling or buckling in the future. It is important to understand that a larger or wider print should be able to move naturally and not be permanently adhered to the backing board. For example, for a wider A2 sized print, you might place three T-Hinges attached across the top. See example below:įor wider prints you might place a T-Hinge approximately every 20-30cm along the edge. ![]() This allows your photo or print to naturally suspend and hang down inside the frame. ![]() It is safer is to just use method called a T-Hinge, which is evenly spaced, cross-layered tabs of acid-free tape positioned along the top edge of the print only, behind the matboard window. When looking to attach a larger or wider print or photo into a larger sized frame, don't apply tape all along the top edge, as this won't allow the print to expand and contract without rippling. Additional tip for larger sized or wider prints, posters and photos: Then flip the mat board over and burnish the tape a bit more to ensure it will adhere. Push the mat board firmly down over the tape to help it to adhere firmly. Next, position the mat board over the photo, align the edges and rest down to adhere the mat board to the tape on the top of the photo. You only need to adhere tape to the top edge, so that your artwork or photo can just hang down. Note: You do not need tape on all sides of the photo. Then place the clear tape on the top edge of the photo, leaving some exposed, and then flip back over face up again. Hold the window mat board over the photo to check the positioning and that the photo will fit properly. Step 4 - Mount the photo to your mat board
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |